This writeup will take you through the steps to get into a 67x modem/router in order to
configure it. Configuring it is an entirely different writeup... =)
This writeup assumes you have:
1) a Cisco
675 or
678 router
2) The provided
management cable
3) A
PC running
Windows 9x
4)
Hyperterminal Installed
How to get in:
1) Go to Start->Programs->Accessories->Communications
2) Click "Hyperterminal"
3) When Hyperterminal loads, it will ask for a name for the
connection. Enter
DSL and click OK
4) Change the Pop-up labeled "
Connect Using" to "Direct to
COM1", then click OK
5) Change "Bits Per Second" to 38400
6) Change "
Flow Control" to "None", then click OK.
7) Press the
Enter Key once.
8) Enter your
exec password, if you have one set. If not, just press enter. If you don't have one set, just press enter.
9) You should see a "
CBOS>" prompt. Type "
enable" and press enter.
10) It will ask for another password, just press enter.
11) At this point you should be presented with a "
CBOS#". You are now able to configure the router.
On other
versions of
Windows, Hyperterminal may not be installed by
default, or could be put in a different folder in the start menu. Once you find it, however, the process should be the same.
Click Here for more info on the Cisco 67x.